Toy Car by sargent7
See all models by sargent7
Download All FilesDownload Individual Parts
Description
This car was designed in Fusion 360. I printed one on my Printrbot Simple. It fits on the standard wooden tracks of common kids train sets i.e. Brio and Ikea.
Rough dimensions after assembly:
-3 in. tall
-3.5 in. long
-1.5 in wide
Note: Superglue will be needed.
Printing Instructions
Inches were used as the units for this model. I printed my parts using Repetier, and I had to scale the model by 25.4, (1 in = 25.4 mm). You may have to do the same depending on your printing software.
Print the following:
-One Car_Body
-Four Car_Wheel(s)
-Four Car_Rims (print vertically)
Assembly: Stick one of the “rims” through one of the wheels so that the hub/end-stop is on the side of the wheel with the indentation. Apply some superglue to the flat part of the axle and stick it through the hole in the car. Perform the same steps with another rim and wheel, and try to arrange the flat ends against each other. Hold until dry.
Printing Stats
| Car_Rim.stl | Time: 0h 0m 0s | Filament used: 0m |
| Car_Wheel.stl | Time: 0h 0m 22s | Filament used: 0.0106372m |
| Car_Body.stl | Time: 0h 0m 0s | Filament used: 0m |
Buy This Printed
Instead of downloading everything and 3D printing it yourself, let us handle it! All printable pieces will be 3D printed by either us, or a trusted manufacturing partner, and then shipped right to your doorstep with no hassle.
Click here to learn more about printing through Lagoon.
Click here to learn more about printing through Lagoon.