Small Spoolholder by JohnSL
See all models by JohnSL
Download All FilesDownload Individual Parts
Description
This is spool holder that is small enough to print on a Printrbot Simple, which is what I used to make these parts.
Printing Instructions
Requires two of these under the rim of the spool. You’ll need a total of 4 608 bearings, 4 M8 25 bolts and nuts, and 8 M8 washers.
Place one washer on each side of the 608 bearning and place into the slot. Run an M8 bolt through the slot and hold in place with an M8 nut. Do not over tighten as you can break the part.
Printing Stats
| Spool_Holder.STL | Time: 3h 11m 58s | Filament used: 2.39527m |
| Spool_Holder_Flat_Bottom.STL | Time: 3h 8m 22s | Filament used: 2.40357m |
Buy This Printed
Instead of downloading everything and 3D printing it yourself, let us handle it! All printable pieces will be 3D printed by either us, or a trusted manufacturing partner, and then shipped right to your doorstep with no hassle.
Click here to learn more about printing through Lagoon.
Click here to learn more about printing through Lagoon.